Interface Modules


 
B201 2-Wire Powered Loop
  • Suitable for use with 2-wire smoke detectors and burglary devices
  • Supports up to 20 compatible smoke detectors
  • Resets latching devices from the control panel
  • Connects to the control panel terminal block with easy-to-install integrated pins
 
 
B810 RECEIVER-SDI2
  • Dual internal antennas provide spatial and polar RF signal reception for high reliability
  • Cover and wall tamper protection
  • Multiple device enrollment options as well as RF diagnostics ensure efficient and effective installation
  • Supports supervision of wireless points (504), keyfobs (1000), and repeaters (8)
  • External status LEDs
  • Detection and reporting of radio frequency interference
 

Features

BubbleLevel EasyInstall Indoor SDI2 Wireless
 
 
B426 Ethernet Communication Module
  • Full two-way IP event reporting with remote control panel programming support
  • 10/100 Base-T Ethernet communication for IPv6 and IPv4 networks
  • NIST-FIPS197 Certified for 128-bit to 256-bitAES Encrypted Line Security
  • Plug and Play installation, including UPnP service to enable remote programming behind firewalls
  • Advanced configuration by browser, RPS, or A-Link
 
 
B430 Plug-in Communicator, Telephone
  • Provides a single telephone line with RJ-45 connection for central station reporting and remote programming
  • Easily configured for communications from Remote Programming Software (RPS) or a keypad, eliminating the need for separate configuration
  • Easy two-step plug-in installation, troubleshooting, and maintenance
 
 
C900V2 Dialer intercept communicator, Ethernet
  • Captures alarm and event data from dialer-based control panels using CONTACT ID, SIA, Modem II, Modem IIe, Modem IIIa2, Pulse, and other formats
  • Performs full data transmissions without changing the data
  • 12 VDC to 24 VDC voltage range
  • Re-routes signals using UDP/IP-based data networks
  • Convenient connection (RJ-45 Jack) to Ethernet networks
  • Integrated 10/100 Network Interface Module, or NIM
  • Provides acknowledgement from the receiver to the control panel
  • Supports 128-bit AES Rijndael encryption
 
 
D135A Low battery disconnect module
  • Disconnects a B6512/B5512/B4512/B3512 from the battery when the battery level drops to 9.5 VDC
  • Required for use with compatible control panels for CAN/ULC S559
  • Quick and easy installation
 
 
DX4010V2 USB/serial interface module
  • RS-232/USB connectivity
  • Enhanced direct connection for Remote Programming Software (RPS)
  • RJ-16 data bus
  • Transparent enclosure
  • Diagnostic light emitting diodes (LEDs)
  • DIP switches for address and bus programming
 
 
ITS-DX4020-G GPRS/GSM integrated communicator
  • Secure IP communication from compatible Bosch panels to Bosch receivers
  • Remote programming of IP compatible Bosch panels
  • GSM reporting from Contact ID control panels to any PSTN receiver
  • Easy provisioning using SMS (text) or USB
  • Easy installation, troubleshooting, and maintenance